Siemens SINAMICS G120P - Page 66

54
Changing the Y-axis right
• If required the Y-axis right can also be configured
• Select “Yes” and press OK
• Choose the required output parameter
• In our example: “Voltage output r0025”
• Press OK
• Select the required unit
• In our example: “Volts”
• Press OK
• Select the required number of unit digits
• In our example: “0”
• Determine maximum value
• Determine minimum value
• In our example: ranging from “0 to 400 V”
• Press OK
OK
OK
OK OK
Yes
OK
OK
0
OK
OK
OK OK
Max value: 0400 Min value: 0
r0025 voltage output
OK
OK
Volts
Operator Panels BOP-2 and IOP-2: Intelligent Operator Panel