Siemens SINAMICS G120P - Page 67

55
Defining the displayed time period and completing the configuration
• Set the required time period for the Trend View
• “Hours”, “minutes” and “seconds” are individually selected
• Press OK to jump from hours to minutes/seconds
• Turn the wheel to change the number of hours/minutes/seconds
• In our example: “2 minutes”
• Press OK to continue
• A summary of settings is displayed
• Review off all settings
• Select “Continue” and press OK
• Select “Save” to complete the configuration
The configuration process is completed by saving all of the settings. The screen will automatically return
to the status screen. The configured graph is immediately displayed. Now switch on the motor to see
how the graph displays selected motor parameters(e.g. motor current, motor frequency). You will see
how the motor accelerates according to the ramp-up time that you configured. Change the motor speed
to see how the graph changes.
2 minutes is a good time period-
for a quick analysis. 24 hours is
recommended for long-term
monitoring.
NOTE
OK
OK OK
OK
Hours Minutes
Save
OK
OK
2
OK
OK
Continue
OK
Seconds