Ensure that access to the holes in the bottom of the cabinets is unobstructed. Remove the
guard covers.
Mounting hardware
To screw the transport units together, you will need the following mounting hardware:
● Self-adhesive sealing strips
● Hexagon nut M8
● Contact washers
● Threaded pin M8 x 15.5
Procedure
To screw transport units together, proceed as follows:
① Holes for threaded pins
② Self-adhesive sealing strips
Figure 5-1 Screwing the transport units together
1. Affix the self-adhesive sealing strips ②.
2. Align the cabinets.
3. Insert the threaded pins through the holes ①.
4. Attach the contact washers to the threaded pins.
5. Screw the transport units together using the nuts with a torque of 32 Nm.
5.3 Connect to the foundation
Four holes for M12 screws are provided on each cabinet panel to secure the cabinet to the
foundation. Information on mounting holes and their fixing dimensions are specified in the
dimension drawing.
Mounting
5.3 Connect to the foundation
SINAMICS GL150 6SL38503UM114PA0Z
Operating Instructions 04/2017 71
To Next Page
Loading...
