See also
Connecting circuit breakers (Page 100)
3.5.2 Expanded remote control via terminal block (option A06)
When using an additional TM31 or TM15 Terminal Module, the quantity structure of control and
status signals is extended at the terminal strip.
3.5.3 Motor monitoring (option A09)
The motor is monitored via the internal SIMATIC S7. The SIMATIC S7 transfers messages to
the Control Unit as message vectors and assigns them to the texts.
3.5.4 Internal synchronizing voltage detection (option A11)
The internal synchronizing voltage detection is used to measure the line voltage.
See also
Voltage actual value sensing (Page 41)
3.5.5 Integrated SIMATIC S7 controller with basic level of equipment
The option includes the SIMATIC S7 basic equipment level comprising the Control Unit
CU315-2 and DP/DP coupler.
3.5.6 Fans in the closed-loop control cabinet (option A20)
A fan is integrated in the closed-loop control cabinet. Operation at temperatures about +40°C
up to a maximum of +45°C is therefore possible. The fans are not redundant. However, the fan
can be replaced in operation. The closed-loop control cabinet can briefly tolerate higher
temperatures. Nevertheless, prompt replacement is advisable.
A fan is integrated in the closed-loop control cabinet. Operation at temperatures about +40°C
up to a maximum of +45°C is therefore possible. The fans are not redundant. However, the fan
can be replaced in operation. The closed-loop control cabinet can briefly tolerate higher
temperatures. Nevertheless, prompt replacement is advisable.
Description
3.5 Options
SINAMICS GL150 6SL38555UN113KA0Z
50 Operating Instructions Rev.201910281450 EXAMPLE
To Next Page
Loading...
