Siemens SINAMICS Intelligent Operator Panel - Page 50

Control
5.1 Custom Hand mode
Intelligent Operator Panel (IOP)
50 Operating Instructions, 08/2015, FW V1.6.1, A5E00110011B AF
Setting up Custom Hand mode example
1.
Select the "Control
".
2.
Select "Custom Hand Mode
".
3.
Select "On: Custom Hand Mode
".
4.
Select "Control Parameter
" to setup the control source.
5.
Select the required function. In this example, the
ON/OFF1 co
mmand is selected.