Siemens SINAMICS Intelligent Operator Panel

To Next Page

To Previous Page

Control

5.3 Hand/Auto disable

Intelligent Operator Panel (IOP)

56 Operating Instructions, 08/2015, FW V1.6.1, A5E00110011B AF

Note

Power-cycle required to complete the HAND/AUTO disable function

When the HAND/AUTO disable function is initiated the function will not become active until a

power

-cycle of the IOP has been performed. When the HAND/AUTO disable function is

turned off, again, a power

-cycle of the IOP is required to complete the deactivation of the

function.

Siemens SINAMICS Intelligent Operator Panel - Page 56