See also
Torques (Page 149)
5.8 Connecting the DC bus
Precise data showing the position of the link rails is provided in the dimension drawing of the
drive.
5.8.1 Preparation
If several cabinets are lined-up to create a group, you must connect the DC bus of the individual
cabinets to one another.
The material provided to connect the DC bus is located in the rear section of the drive.
① Link rails ③ Transport box with mounting hardware
② Support element ④ Bracket
Figure 5-4 Storage of link rails with mounting hardware
1. Remove the link rails from the support elements (number depending on the drive type).
2. Remove the mounting hardware from the transport box.
Installation
5.8 Connecting the DC bus
SINAMICS SM150 6SL3845-7NN46-7AA2
80 Operating Instructions Rev.201910281345 EXAMPLE
To Next Page
Loading...
