6.5.10 Fastening the cable ducts with cable ties
Fasten all cable ducts whose cover faces downward with cable ties. Wind the cable ties around
the entire cable duct. The cable ties must be located at the same positions as in the delivered
state.
Figure 6-8 Schematic diagram: Fastening the cable ties
6.6 Mounting the rear panel
After all installation and connecting work has been completed, reattach the rear panels to the
individual transport units that were removed during preparatory work.
Electrical connection
6.6 Mounting the rear panel
SINAMICS SM150 6SL3845-7NN46-7AA2
Operating Instructions Rev.201910281345 EXAMPLE 99
To Next Page
Loading...
