Siemens SINAMICS V20 - 3 Commissioning; The Built-In Basic Operator Panel (BOP)

SINAMICS V20 Inverter
A5E37281078-003, 05/2016
15
3
Commissioning
WARNING
Hot surface
During operation and for a short time after switching-off the inverter, the marked surfaces of the inverter can
reach a high temperature. Avoid coming into direct contact with these surfaces.
3.1
The built-in Basic Operator Panel (BOP)
Button functions
Stops the inverter
Single press
OFF1 stop reaction in HAND mode.
Exception:
This button is inactive if the inverter is configured for control from terminals or
USS/MODBUS on RS485 (P0700=2 or P0700=5) in AUTO mode.
Double press (< 2 s)
or long press ( > 3 s)
OFF2 stop reaction: the inverter allows the motor to coast to a standstill without using
any ramp-down timings.
Starts the inverter in HAND / JOG /AUTO mode.
Exception:
This button is inactive if the inverter is configured for control from terminals or USS/MODBUS on RS485
(P0700=2 or P0700=5) in AUTO mode.
Multi-function button
Short press ( < 2 s) • Enters the parameter setting menu or moves to the next screen in the setup menu
• Restarts the digit by digit editing on the selected item
• Returns to the fault code display
•
Press twice in digit by digit editing to discard change and return
Long press ( > 2 s) • Returns to the status screen
•
Enters the setup menu
Short press ( < 2 s) • Switches between status values
• Enters edit value mode or change to the next digit
• Clears faults
•
Returns to the fault code display
Long press ( > 2 s) • Quick parameter number or value edit
•
Accesses fault information data
+
Press to switch between HAND (with hand icon) / JOG (with flashing hand icon) / AUTO (no icon) mode.
Note:
Jog mode is only available if the motor is stopped.
• Moves the selection up through a menu, increases a value or a setpoint.
• Long press (>2 s) to quickly scroll up the values.