Siemens SINAMICS V20 - Quick Commissioning; Powering up and Setting to Factory Defaults

SINAMICS V20 Inverter
A5E37281078-003, 05/2016
17
Digit-by-digit editing of parameters
3.2
Quick commissioning
3.2.1
Powering up and setting to factory defaults
Operating sequence
1. Switch on the inverter and then start from the display menu.
2. Press for less than 2 s to switch to the parameter menu.
3. Press
or to select P0010 and set P0010 = 30 with .
4. Press to select P0970 and set P0970 =1 or P0970 = 21 with .
Note
This section describes how to perform the quick commissioning through the setup menu. If you are used to commissioning
the inverter by setting parameters of your choice in the parameter menu, refer to the SINAMICS V20 Inverter Operating
Instructions for a detailed description.
Structure of the setup menu