SINAMICS V20 Inverter
18 A5E37281078-003, 05/2016
Overview of connection and application macros
Connection macros (Page 18)
Application macros (Page 21)
No chosen connection macro
External push button control
Cn001 BOP as the only control source Cn007 External push buttons with
AP010 Simple pump applications
Cn002 Control from terminals
(PNP/NPN)
Cn008 PID control with analog
reference
AP020 Simple fan applications
Cn003 Fixed speeds Cn009 PID control with the fixed
AP021 Compressor applications
Fixed speeds in binary mode
Analog input and fixed frequency
P0100 50/60 Hz selection
=0: Europe [kW], 50 Hz (factory default)
=1: North America [hp], 60 Hz
=2: North America [kW], 60 Hz
P0309[0] ● Rated motor efficiency [%]
Rated motor frequency [Hz]
P0307[0] ● Rated motor power [kW/hp] P1900 Select motor data identification
= 0: Disabled
= 2: Identification of all parameters in standstill
Rated motor power factor (cosφ)
Note: "●" indicates that the value of this parameter must be entered according to the rating plate of the motor. If P0100 = 1
(60 Hz [hp]), P0308[0] is invisible which indicates that this parameter is unnecessary for configuration.
Setting connection macros
Functionality
This menu selects which macro is required for standard wiring arrangements. The default one is "Cn000" for connection
macro 0.
Cn001 - BOP as the only control source
Cn002 - Control from terminals (PNP/NPN)
External control - Potentiometer with setpoint
Both NPN and PNP can be realized with the same parame-
ters. You can change the connection of the digital input com-
mon terminal to 24 V or 0 V to decide the mode.
To Next Page
Loading...
