Siemens SINAMICS V60 - Page 17

Controlled Power Module (CPM60.1)
A5E03975175-002, 04/2014
17
Note
As 65 signal from SINAMICS V60 drive is recommended for emergency stop, it is not used in SIMATIC PLC/SINAMICS V60
signal cable.
For a SIMATIC PLC (S7-
200 series), signal PULS can only be connected to output terminal Q0.0 or Q0.1, and terminal Q0.2
or Q0.3 is used for direction output.
For PNP and NPN types, connectors on X5 are differently arranged. So, be sure to connect to X5 correctly according to the
actual situation.
Based on contact colors, connect the contacts on the PLC (left) and those on the V60 (right) respectively, as shown on page
EN-13. The contact colors on the PLC, however, do not match those on the V60.
● If the SIMATIC PLC is an S7-1200 controller, see the following wiring diagram (example):
Note
As 65 signal from SINAMICS V60 drive is recommended for emergency stop, it is not used in SIMATIC PLC/SINAMICS
V60 signal cable.
For a SIMATIC PLC (S7-
1200 series), signal PULS can only be connected to output terminal Q0.0 or Q0.2, and terminal
Q0.1 or Q0.3 is used for direction output.
External 24 V DC Power Supply
The CPM60.1 drive unit should be connected to an external 24 V DC power supply (rated input current 2 A), which enables
the drive to normally work under the voltage range of 24 V (-15% to +20%). Since the excellent quality of a DC power supply
is critical to the stable operation of a drive system, Siemens recommends you to select a Siemens DC 24 V stabilized power
supply (order number: 6EP1333-3BA00). If there is no Siemens DC 24 V power supply available, you can use a non-
Siemens high-quality power supply instead.
Filter
A line filter (rated current 16 A, protection level IP20) is required so that the system can pass the CE certification (radiated
emission test or conducted emission test). The filter recommended by SIEMENS has an order number of 6SN1111-0AA01-
1BA1.
Circuit breaker
You can install a mains linear breaker (rated current: 15 A for 7 A or 10 A version of the drive and 10 A for 4 A or 6 A version
of the drive; rated voltage: 250 V AC) to protect the system.
SIMATIC PLC/SINAMICS V60 signal cable
It is recommended to use SIEMENS-designed SIMATIC PLC/SINAMICS V60 signal cable (length: 3 m) to connect SIMATIC
PLC and SINAMICS V60. This signal cable can be ordered with MLFB of 6ES7298-2DS23-0XA0.