Setup functions
3.4 Face milling in MDI mode
SINUMERIK 802D sl pro - Milling
16 Control system overview for machine tools' sales people, 07/2008
3.4 Face milling in MDI mode
☑ Basic configuration
When preparing a blank workpiece, SINUMERIK 802D sl pro supports you in the following
ways:
● Input of machining parameters by dialog, complete with tool, work offset, feedrate,
spindle speed and direction
● Selection of the machining strategy via softkey
● There is no need for programmers to write the part programs themselves. After entering
the machining parameters, press OK and the program will be created automatically.
● The MDI blocks are also retained after NC Start and can be saved as a part program.
Highlight
● Speedy preparation of the blank workpiece
To Next Page
Loading...
