PLC Subroutines Manual
6FC5397-0FP40-0BA0, 08/2013
23
You can write the transferred data into the permanent memory (load memory) of the control system with the PLC
Programming Tool or a USB stick.
To download a PLC application with the PLC Programming Tool, proceed as follows:
1. Establish the communication between the control and the PLC Programming Tool.
You can establish the connection by using the following three methods:
● Establishing a connection with the RS232 interface (Page 13)
● Establishing a direct connection with the Ethernet interface (Page 17)
Establishing a network connection with the Ethernet interface (Page 20)
→
2.
Choose these two menus from the menu bar or click the download icon to start the download,
and the download dialog pops up:
To Next Page
Loading...
