Siemens SINUMERIK 808D ADVANCED T - Page 24

PLC Subroutines Manual
24 6FC5397-0FP40-0BA0, 08/2013
3. Click this button to proceed directly. You can also select the checkbox "Data Blocks (only actual
values)" to include the actual values of the data blocks, and then click this button.
4. Choose to download the PLC application when the PLC is in the
run
mode or in the
stop
mode.
Caution
: You are recommended to download the PLC application when the PLC is in the
stop
mode.
Downloading the PLC application when the PLC is in the
run
mode can cause machine damages or
even human injuries.
5. The download starts and it will take several seconds to do it.
6. The download finishes when the following message appears. Then click this button to end your
operations.
Note
If you have chosen to download when the PLC is in the
stop
mode, you can place the PLC at the
run
mode again with the
PLC Programming Tool (click the button
).