EasyManuals Logo

Siemens SINUMERIK 840C Installation Guide

Siemens SINUMERIK 840C
189 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #154 background imageLoading...
Page #154 background image
09.95 5 PLC Interface
5.3.4 Spindle-specific signals (DB31)
5.3.4 Spindle-specific signals (DB31)
5.3.4.1 Signals from spindle
7 6 5 4 3 2 1 0
Bit No.
Byte No.
DL K
Actual dir.
or rotation
clockwise
Progr.
speed too
high
Spindle in
set range
Spindle
position
reached
Spindle has
stopped
Spindle
synchroni-
zed
Spindle
positioning
running
Speed limit
exceeded
DR K
Change
gear C B A
Signals from spindle
Set gear stage
15 14 13 12 11 10 9 8
5.3.4.2 Spindle-specific GI signals
1)
7 6 5 4 3 2 1 0
Bit No.
Byte No.
DL
K+24
Accel.
limitation
synchron.
active
ESR
monitoring
is
active
Compensat.
controller
active
FA
overlay
active
Synchron-
ism active Link active
DR
K+24
FA
controlled
follow-up
Max.
accelera-
tion
Max.
velocity
Acc.
warning
threshold
reached
Acc.
warning
threshold
reached
Synchron-
ism fine
Synchron-
ism coarse
DL
K+25
Synchron-
ized pos.
reached
ESR
response
activated
DR
K+25
Identifier
following
spindle
ESR
response
is program-
med
2)
LINK_OFF
request
LINK_ON
request
DL
K+49
Slave mode
is active
again
3)
C axis
active
2)
DR
K+49
Signals from spindle
15 14 13 12 11 10 9 8
GI = Gear interpolation
________
1) SW 3 and higher
2) SW 4 and higher
3) SW 4.4 and higher
© Siemens AG 1992 All Rights Reserved 6FC5197- AA60 5–37
SINUMERIK 840C (IA)

Table of Contents

Other manuals for Siemens SINUMERIK 840C

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 840C and is the answer not in the manual?

Siemens SINUMERIK 840C Specifications

General IconGeneral
BrandSiemens
ModelSINUMERIK 840C
CategoryControl Unit
LanguageEnglish

Related product manuals