2.2.6 Recovering a Non-responsive Board
See section Restoring/Updating Platform via SD Card [➙ 16] for details.
2.2.7 ACC-G2 Firmware Update Procedures
See section Common Firmware Update Procedure [➙ 11] for details.
2.2.8 Restoring/Updating Platform via SD Card
2.2.8.1 Preparing the SD Card
Before you begin, prepare the SD Card by following the steps below:
1. Insert the SD card into the computer (512MB minimum - 2 GB maximum,
512MB recommended for compatibility with older ACC revisions).
2. Find compressed
.gz
image in
SD_Card
folder. Unzip to extract the
.wic
file.
3. Use
Win32DiskImager
(in
Tools\ACC-G2 SD-Card Creator Tool
folder) to write
the
~.wic
file to the SD Card.
Win32DiskImager
defaults to open a file of extension type
*.img
, so select
*.*
,
browse to the location of the SD card image file and load it, then click the Write
button.
Note: Win32DiskImager must be installed on your computer, not on the SD card.
To Next Page
Loading...
