Siemens SiPass integrated

Firmware Configuration Tools
ACC USB Client Application
1
A6V11164550
3 | 38
Table of Contents
1 Firmware Configuration Tools ..................................................................... 5
1.1 ACC USB Client Application ........................................................................... 5
1.1.1 Installing the USB RNDIS Driver ..................................................... 5
1.1.2 Configuring the ACC USB Client Application .................................. 6
1.2 ACC and FLN Field Service Network Tool ...................................................... 7
1.2.1 Installation ........................................................................................ 7
1.2.2 Downloading Firmware for Device ................................................... 7
1.2.3 Network Discovery for Access Controllers ...................................... 8
1.2.4 Enhanced FLN Communication ....................................................... 9
1.3 Built-in ACC Tools ......................................................................................... 10
1.3.1 User Security for ACC Console ..................................................... 10
1.3.2 User Security for ACC-Lite LCD / Keypad Menu ........................... 10
2 Access Controllers .................................................................................... 11
2.1 Common Firmware Update Procedure ......................................................... 11
2.1.1 Updating Controller Application via Firmware Download .............. 11
2.1.2 Updating Controller Platform via Firmware Download................... 12
2.2 AC5102 (ACC-G2) ........................................................................................ 14
2.2.1 Configuring the AC5102 Controller using
USB Client Application ................................................................... 14
2.2.2 Network Discovery of AC5102 ....................................................... 14
2.2.3 Configuring the AC5102 Port Mapper ........................................... 14
2.2.4 RS232 mode on FLN 2 and FLN 3 ................................................ 15
2.2.5 Restoring Default Network and Password Settings ....................... 15
2.2.6 Recovering a Non-responsive Board ............................................. 16
2.2.7 ACC-G2 Firmware Update Procedures ......................................... 16
2.2.8 Restoring/Updating Platform via SD Card ..................................... 16
2.2.8.1 Preparing the SD Card ................................................... 16
2.2.8.2 SD-Card Upgrade Procedure ......................................... 17
2.2.8.3 SD Card Update Troubleshooting .................................. 18
2.2.9 Network Security ............................................................................ 18
2.3 ACC-AP ......................................................................................................... 19
2.3.1 General Information ....................................................................... 19
2.3.2 Configuring the ACC-AP Controller ............................................... 19
2.3.3 Onboard Door (DRIe) Interfaces.................................................... 20
2.3.3.1 Dual OSDP Reader Door Configuration ......................... 20
2.3.3.2 2 Single OSDP Reader Doors Configuration ................. 20
2.3.3.3 OSDP Reader Turnstile,
Single Door Contact Configuration ................................. 21
2.3.3.4 OSDP Reader Turnstile, Dual Door Contact
Configuration.................................................................................. 21
2.3.3.5 Dual Wiegand Reader Door Configuration ..................... 22
2.3.3.6 2 Single Wiegand Reader Doors Configuration ............. 22
2.3.3.7 Wiegand Reader Turnstile,
Single Door Contact Configuration ................................. 23