SFIDK.PS.029.Q3.02 23
5. Signal converter installation
Signal conv. inst.
SITRANS F US SONOFLO
®®
®®
®
5.6.3 Front of panel
mounting
1. Mount the connection plate in the panel set using 4 screws.
2. Mount the panel set as shown in the figure.
3. Fit the SENSORPROM
®
unit on the connection plate of the signal converter.
(The SENSORPROM
®
unit is located in the terminal box of the sensor).
4. Insert the signal converter into the frame and fasten with the four screws accessible from
the front panel.
5. Connect the cables as shown under "Electrical connection".
5.6.4 Back of panel
mounting
1. Mount the connection plate in the back of the panel with four screws.
2. Fit the SENSORPROM
®
unit on the connection plate.
(The SENSORPROM
®
unit is located in the terminal box of the sensor).
3. Connect the cables as shown under "Electrical connection".
4. Mount the back of panel housing with four screws.
5. Insert the signal converter into the panel.
To Next Page
Loading...
