Siemens SITRANS SL - Page 103

Commissioning
6.3 PROFIBUS configuration for SITRANS SL
SITRANS SL
Operating Instructions, 12/2010, A5E01132948-04
105
3. In the HW Config window you can check the number of blocks and the address
assignment.
Measurement Type Selection
● Concentration measurement output
First input module in the first slot. Consists of 4 byte float value and 1 byte status value.
●
Transmission value (absolute transmission) output
Third input module in the third slot. Consists of 4 byte float value and 1 byte status value.
●
Temperature input :
First output module in the fifth slot. Consists of 4 byte float value and 1 byte status value.
●
Pressure input:
Second output module in the sixth slot. Consists of 4 byte float value and 1 byte status
value.