Description
2.4 Design
SITRANS SL
Operating Instructions, 12/2010, A5E01132948-04
17
Non Ex version and sensor connection cable kit
① Transmitter housing ⑨ Large cable gland (for cables with a diameter of
13 ... 18 mm)
② Transmitter tube unit ⑩, ⑪ Small cable gland (for cables with a diameter of
8 ... 12 mm)
③ Process interface ⑬ Reference cell inside the receiver unit
④ Customer flange (not included) ⑭ Remote control
⑤ Purging tube (accessory) Sensor connection cable kit (accessory), consisting of
⑥ Receiver tube unit ⑫ Sensor connection cable
⑦ Receiver housing ⑮ Receiver junction box
⑧ Connection cable (accessory) ⑯ Receiver junction box cable
⑰ Cable gland for Ethernet cable
Figure 2-2 Connection of a non Ex system with the sensor connection cable kit (accessory)
The sensor connection cable is used to connect the transmitter unit to the receiver unit. This
can be done either directly, or via a receiver junction box (see preceding figure). A sensor
connection cable kit is available as accessory.
To Next Page
Loading...
