Siemens SL75 - Charging the Battery

Getting started16
© Siemens AG 2003, E:\Auftrag\Siemens\MobilePhones\FCCs\sl75\FUG\HYDRA_Startup.fm
left page (16) of SL75 Hydra FUG, w/o ptt, us-en, A31008-H3300-A1-1-7619 (06.10.2005, 15:39)
Template: X75, Version 2.2;VAR Language: am; VAR issue date: 050822
• Position the battery cover on the
device, slightly offset at the
top
6
, and then push in the direc-
tion of the arrow until it clicks into
place
7
.
• To remove, press the locking but-
ton
8
, push the battery cover
forwards slightly, and then lift it
up and out
9
.
Charging the battery
Charging
The battery is not fully charged
when delivered. Plug the charger ca-
ble into the bottom of the phone,
plug the power supply unit into a
mains power socket and charge
for at least two hours (for charging
via USB, see page 92). Do not
interrupt the charging procedure
prematurely.
à
Display when charging is
in progress.
Charging time
An empty battery is fully charged af-
ter about 2 hours. Charging is only
possible within a temperature range
of +5°C to +45°C (41°F to 113°F). If
the temperature rises/falls 5°C (9°F)
above/below this, the charge symbol
flashes a warning. The mains voltage
specified on the power supply unit
must not be exceeded.
Additional information
Please switch off your phone before remov-
ing the battery!
1.8 and 3 volt SIM cards are supported.
Please contact your service provider if you
have a different card.
6
7
9
8