Siemens Synco 700 RMZ785 - Page 129

9.1.4 Assign texts
You can assign a text to each "Min-Max-Average" block.
Main menu > Commissioning > Settings > .... or
Main menu > Settings > Signal converter > Min-Max-Average 1…2 >
Operating line Range Factory setting
Min-Max-Average 1.. 2
Max. 20 characters
Min-Max-Average 1…2
Setting values
See Section 16.4 "Editable texts RMS705B" for an overview of all editable texts
and on how to
reset them.
9.1.5 Function check / wiring test
The inputs and outputs of the "Min-Max-Average" block are displayed on the
operator unit.
Main menu > Signal converter > Min-Max-Average 1…2 >
Display values
Operating lin
e Comment
Minimum A
0...100 %, °C, ppm, type-dependent.
Maximum A
0...100 %, °C, ppm, type-dependent.
Average A
0...100 %, °C, ppm, type-dependent.
Minimum B
0...100 %, °C, ppm, type-dependent.
Maximum B
0...100 %, °C, ppm, type-dependent.
Average B
0...100 %, °C, ppm, type-dependent.
Input 1…5
0...100 %, °C, ppm, type-dependent.
You can directly control "Min-Max-Average" during the wiring test. Wirin
g test
Main menu > Commissioning > Wiring test > Outputs >
Operating line Comment
[Min-Max-Avrg 1] A ----, 0...100 %
[Min-Max-Avrg 1] B
----, 0...100 %
[Min-Max-Avrg 2] A
----, 0...100 %
[Min-Max-Avrg 2] B
----, 0...100 %
130 / 216
Siemens Switching and monitoring device RMS705B CE1P3124en
Building Technologies Signal converter 01.04.2010