You can copy a 7-day program containing all entries to another time switch. To do
this, select the desired time switch (e.g. Time switch 3).
Copy 7-day p
rogram
s
T
urn the pres
s-and-turn button to the right. "Copy to" is displayed at the end of the
7-day list. You can copy the selection to either all or to one single time switch.
The data is copied if the target time switch is activated.
Note
7.1.3 Assign texts
You can assign text to each time switch and operation selector. The text is
displayed on the menu and in the operating line.
Main menu > Commissioning > Settings > … or
Main menu > Settings > Time switch > Time switch 1…6 >
Free text
Operating line Range Factory setting
Time switch 1…6 Max. 20
characters
Time switch 1…6
[Time switch 1] op selector...
[Time switch 6] op selector
Max. 20
characters
[T'swi 1] op sel
See Section 16.4 "Editable texts RMS705B" for an overview of all editable texts
and on how to
reset them.
7.1.4 Operation selector
You can preselect the operating mode for the time switch’s output via the operation
selector in the main menu. The current state for the operation selector of time
switch 1, e.g., is displayed as follows:
Main menu > [Time switch 1] op selector >
Display values
Operating lin
e Comment
Preselection Auto, Off, On.
State Display of present state: Off, On.
You must first ensure that the operation selector is set to Auto if you want to reset
its configuration later on. Otherwise, the time switch constantly maintains "On" or
"Off".
Important note
62 / 216
Siemens Switching and monitoring device RMS705B CE1P3124en
Building Technologies 7-day time switch 01.04.2010
To Next Page
Loading...
