Siemens Synco 700 RMZ785 - Page 74

8.2.2 Assign texts
You can assign a text to each comparator. The text is displayed on the menu and in
the operating line.
Main menu > Commissioning > Settings > .... or
Main menu > Settings > Aggregates > Logic functions > Comparator 1...2 >
Operating line Range Factory setting
Comparator 1…2 Max. 20 characters Comparator 1…2
Setting values
See Section 16.4 "Editable texts RMS705B" for an overview of all editable texts
and on how to
reset them.
8.2.3 Upper and lower limit value
The comparator switches on when Limit value on is exceeded, and off when the
value is below Limit value off.
Main menu > Commissioning > Settings > .... or
Main menu > Settings > Aggregates > Logic functions > Comparator 1...2 >
Setting values
Operating line Range Factory setting
Limit value on Depending on selected type. Type-dependent.
Limit value off Depending on selected type. Type-dependent.
8.2.4 Switch-on/switch-off delay
You can set a switch-on and switch-off delay for the comparator output.
Main menu > Commissioning > Settings > .... or
Main menu > Settings > Aggregates > Logic functions > Comparator 1...2 >
Setting values
Operating line Range Factory setting
Switch-on delay 00.00...59.59 m.s or*
00.00...23.50 h.m
00.00 m.s
Switch-off delay 00.00...59.59 m.s or*
00.00...23.50 h.m
00.00 m.s
* See Notes on the time format in Section 8.2.1
The "Switch-on delay" acts on the switch-on command, the "Switch-off delay" on
the switch-off command.
75 / 216
Siemens Switching and monitoring device RMS705B CE1P3124en
Building Technologies Aggregates 01.04.2010