9 – 19
Modifying the angle of the display
At the factory, the alphanumeric display is installed with a downward inclination. However, it can be turned in a vertical direction by 180°, the
display is then inclined upwards.
- OPEN the circuit breaker and discharge the closing spring (page 24-2)
- Disconnect external 24 V DC voltage supply, if applicable
- Remove trip unit sealing cap, if applicable (page 9-53)
Removing the display
DANGER
Hazardous voltage.
Will cause death, serious personal injury, or equipment damage.
Turn off and lock out all power supplying this equipment before working on this device.
To Next Page
Loading...
