14 – 2
Supplied Components:
(1) 2x access blocks. Button is only accessible with a 1/8" pin (or smaller) (page 17-2)
(2) 2x sealing caps for sealing or attaching a padlock to block the button (page 15-21)
(3) Shield to prevent inadvertent operation
(4) Mounting plate
Catalog No.
NOTICE
Damage to accessory.
Over-tightening the mounting screws may strip the plastic frame, or damage components, rendering the accessory unusable.
Hardware shall be tightened carefully until the underside of the screw head is flush with the mounting surface.
Catalog No.
Locking set WLLKKT
OPEN
CLOSE
3
2
1
PZ 1
hand tighten
To Next Page
Loading...
