15 – 5
Components of the key locking device
1
2
3
4
5
6
789
10
11
12
13
14
17
15
16
(1) Countersunk head screw M6 with belleville washer and nut
(2) M4 socket head cap screw
(3) Pre-assembled skid with guide
(4) Lever
(5) Spacer
(6) Kirk key, supplied separately including fixing screws
(7) Bolt with washer size 5 mm and clip (for 4 mm inner diameter
groove; (for 4 mm groove; for FS II only)
(8) 3x M4 socket-head cap screws with lock waschers and nuts (for
FS III only)
(9) Extension (for FS III only)
(10) Bolt with washer size 5 mm and clip (for 4 mm inner diameter
groove; (for 4 mm groove; for FS II only)
(11) Ramp extension (for FS III only)
(12) 2x M4 flat-head screw (for FS III only)
(13) Small attachment angle
(14) 2x M4 socket-head cap screws
(15) Spacer (for FS II only)
(16) Plastic slider (slotted)
FS II / III: short slot
FS II fused: long slot
(17) 2x spring lock washers
To Next Page
Loading...
