Cleaning and servicing en
39
Display Basic setting Selection
Cooling fan run-on time = short
1
= moderate
= long
= extra long
Reset all values to factory settings = No
1
= Yes
Activate demo mode.
The demo mode is used for demonstration purposes
only. The appliance does not heat up in demo mode.
You can activate the demo mode only in the first
5minutes after connecting to the power supply.
= No
1
= Yes
1
Factory setting
10.2 Changing the basic settings
Requirement:The function selector is set to the off po-
sition.
1.
Press and hold for approx. 4seconds.
a The display shows the first basic setting, e.g. .
2.
Turn the temperature selector to change the setting.
3.
Press to switch to the next basic setting.
4.
Press and hold for approx. 4seconds to confirm
the settings.
Tip:You can change the basic settings again at any
time.
Notes
¡ You can activate the demo mode only in the first
5minutes after connecting to the power supply.
¡ Your changes to the basic settings are retained
even after a power cut.
10.3 Setting energy-saving mode
You can save energy by reducing the display bright-
ness.
▶
You can set the display brightness under basic set-
ting .
Note:This setting changes the brightness of the dis-
play while the appliance is in operation. In standby
mode, the appliance automatically reduces the display
brightness. The display is at its dimmest at night,
between the hours of 22:00 and 05:59.
Cleaning and servicing
11 Cleaning and servicing
Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
11.1 Cleaning products
To avoid damaging the various surfaces on the appli-
ance, do not use any unsuitable cleaning agents.
WARNING‒Risk of electric shock!
An ingress of moisture can cause an electric shock.
▶ Do not use steam- or high-pressure cleaners to
clean the appliance.
ATTENTION!
Unsuitable cleaning agents damage the surfaces of the
appliance.
▶ Do not use harsh or abrasive cleaning products.
▶ Do not use cleaning products with a high alcohol
content.
▶ Do not use hard scouring pads or cleaning
sponges.
▶ Do not use any special cleaners for cleaning the ap-
pliance while it is hot.
▶ Only use glass cleaners, glass scrapers or stainless
steel care products if recommended in the cleaning
instructions for the relevant part.
Using oven cleaner in a hot cooking compartment
damages the enamel.
▶ Never use oven cleaner in the cooking compartment
when it is still warm.
▶ Remove all food remnants from the cooking com-
partment and the appliance door before you next
heat up the appliance.
Salt contained in new sponge cloths may damage sur-
faces.
▶ Wash new sponge cloths thoroughly before use.
11.2 Suitable cleaning agents
Only use cleaning agents that are suitable for the differ-
ent surfaces on your appliance.
Appliance exterior
Follow the instructions on cleaning the appliance.
Area Suitable cleaning agents Information
Stainless steel front ¡ Hot soapy water
¡ Special stainless steel clea-
ning products suitable for hot
surfaces
To prevent corrosion on stainless steel fronts, remove
any limescale, grease, starch and albumin (e.g. egg
white) stains immediately.
Apply a thin layer of the stainless steel cleaning product.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
