Siemens WF 723 C User Manual

Programming of Traversing Blocks 04.97
• Programming with G63 (path-dependent chaining)
Programming:
N10 G77 G63 X100.000 FX1000.00 (FX500.00)
N20 X200.000 Y100.000 FY1000.00 (FY500.00)
a a a a
a
a a
a
a
a a
a
a a a a
➀
a a a
a
a
a
a
a
a
a a a
s
a a a a a
a
a a a
a
a
a a a
a
a
a a a
a
a a a a a
v
X
a a a a a a a a a
a
a a a a a a a
a
a
a a a a a a a
a
a a a a a a a a a
200.000
a a a
a
a
a
a
a
a
a a a
s
a a a a
a
a a
a
a
a a
a
a a a a
v
y
a a a a a
a
a a a
a
a
a a a
a
a a a a a
➀ '
a a a a a a a a a
a
a a a a a a a
a
a
a a a a a a a
a
a a a a a a a a a
1000.00
a a a a a a a
a
a a a a a
a
a
a a a a a
a
a
a a a a a
a
a a a a a a a
500.00
a a a a a a a a a
a
a a a a a a a
a
a
a a a a a a a
a
a a a a a a a a a
1000.00
a a a a a a a
a
a a a a a
a
a
a a a a a
a
a a a a a a a
500.00
100.000
With G63, the coupling of the Y-axis is decelerated until the actual value of the X-axis has
reached the programmed position value (in the example: 100.000). That means that the
amounts of speed, deceleration or time override have not influence on the coupling, so
that coupling can only be delayed by the WF cycle time (2 ms).
The function G63 is derived from G64, i.e. if path-dependent chaining is
not possible, G63 will have the same effect as G64.
4 – 28 © Siemens AG 1997 All Rights Reserved 6ZB5 440-0VU02
WF 723 C (Programming Guide)

Siemens WF 723 C Specifications

General

Brand	Siemens
Model	WF 723 C
Category	Control Unit
Language	English