Instructions, use and maintenance manual Pag. 4/49 SAU 160-200
1. General information
This instructions, use and maintenance manual provides the necessary instructions for machine transportation,
commissioning, use and maintenance and it must be consulted before performing any of these operations.
The manual must be read by the maintenance technicians and by the machine operators who must perform their
tasks correctly.
The manual is an integral part of the machine and it must be kept in an adequate place to ensure its integrity and
availability for consultation throughout the machine life-span.
In case of loss or deterioration, request a copy from the manufacturer, clearly specifying all of the machine
identification data (year or manufacture, model, serial number).
All references and/or instructions in this manual relating to:
• CE marking;
• CE declaration(s) of conformity;
• declaration(s) of incorporation of the partly-completed machine;
• directives and regulations issued by the EU institutional bodies (Parliament, Council, Commission, etc.) and
related transposition deeds of the EU member states;
• European harmonised standards,
are to be considered valid only for the machines intended to be placed on the EU market or for which compliance
with Laws, Directives, etc. issued by the EU was expressly required by the customer and formally accepted by
SIGMA SRL.
These references and instructions have no meaning and value for all machines not intended for the EU market,
apart from the above exceptions.
1.1. Foreword
This manual is intended for all those in charge of installation, use and maintenance of the machinery in question,
so that they can make the best use of the product features.
It is important to keep this manual and ensure it follows the machine in all its transfers, including change of
ownership, so that it can be consulted for the necessary information on safe operation.
The manufacturer is not obliged to notify any subsequent product changes.
It also reserves the right to ownership of this document in accordance with the law and prohibits
tampering, reproduction and transmission to third parties without its authorisation.
The following symbols are used to highlight some parts of the text:
PERSONNEL QUALIFICATIONS: symbols used to indicate the specific competence required for the operation
(they will be discussed further in the GLOSSARY chapter).
ATTENTION: indicates hazardous situations for which particular caution is required.
To Next Page
Loading...