Sigma 4-15C - Page 51

Operating Manual SIGMA 4-15C, page 51 of 95
03/06
5.1.1 Selection and Alteration of the Parameters and Activation of the
Start Delay and the Automatic Lid Opening after End of Run
Selection and alteration of the parameters
• Select the area "Parameters" (PARA) by turning the knob (selection mode)
and confirm by pressing the knob.
• The parameters to be changed, e.g. acceleration, deceleration, radius, density
and the start delay and automatic lid opening after end of run can be selected
(here: acceleration).
• Confirm the selected parameter by pressing the knob (here: acceleration). The
parameter is activated. Select the desired acceleration curve by turning the
knob.
Deceleration, radius and density are changed in the same way.