General considerations
To ensure good adhesion between the printing surface
and the 3D printed part, you will need to use an
adhesive product that will be applied to the printing
surface before start printing. For general materials,
we recommend using the glue stick included with the
printer or a generic lacquer. However, for technical
materials such as ABS or PET-G, we recommend
Dimafix adhesive, available at our website.
We recommend using an enclosure when printing with
technical materials such as ABS, Nylon or PET-G. It
provides a constant interior temperature to prevent
warping and protects your working environment from
potentially harmful particles thanks to the HEPA filter.
More information at our website.
Nylon and PVA plastic are hygroscopic, that means
it readily absorbs water from the air. Make sure they
are dry before printing. Place them in an oven or in a
dehydrator at 50 ºC for 6 to 8 hours. After drying, store
it in an airtight container with desiccant.
Filament
52 User Manual
To Next Page
Loading...
