Maintenance Plan
We recommend you carry out the maintenance procedures described in the table below in order to keep your prin-
ter running optimally. The procedures are grouped depending on frequency they should be performed is shown on
the right.
Daily
ACTION TO PERFORMFREQUENCY
Weekly
Monthly
Quarterly
Keep the printer free of dust and in a dry, cool place
Storage the spools in a dry, cool place
Remove the filament inside the Purge Tank
Remove the filament leftovers spread inside the printer
Clean the glass printing surface with warm water and soap
Clean the nozzles
Level the printing surface glass (also after a transportation)
Clean fans dust
Printer calibration (also after a transportation or replacing a hotend)
Check firmware updates
Check bolted and threaded joints
Clean and lubricate axes
Check tension of extruder springs
Check X/Y belt tension
Check connections of moving cables
User Manual 53
To Next Page
Loading...
