C-DIAS PROCESSOR MODULE CCP 611
27.03.2020 Page 3
10 CAN Bus Termination ........................................................... 21
11 Wiring and Mounting Instructions ....................................... 22
11.1 Ground ......................................................................................... 22
11.2 Shielding ...................................................................................... 23
11.3 ESD Protection ............................................................................ 23
12 Working With and On the CCP 611 ...................................... 23
13 Process Diagram ................................................................... 24
14 System Boot Checkpoints .................................................... 25
15 Status and Error Messages .................................................. 26
16 Application Exceptions ......................................................... 35
16.1 SRAM and IRQ routines ............................................................. 35
16.2 SRAM and Consistency of Changed Data ................................ 35
16.3 The File System Does Not Support Safe Writing via SRAM ... 35
16.4 Data Breakpoint .......................................................................... 35
17 Note on SRAM Behavior ....................................................... 36
18 Recommended Shielding for VARAN .................................. 37
18.1 Wiring from the Control Cabinet to an External VARAN
Component .................................................................................. 38
18.2 Wiring Outside of the Control Cabinet ..................................... 39
18.3 Shielding for Wiring Within the Control Cabinet ..................... 40
To Next Page
Loading...
