MDP 101-1
05.06.2020 Page 11
The servo amplifier from SIGMATEK GmbH & Co KG was designed and produced with
state of the art technology. Before delivery, the products are completely tested for reliability.
It is a built-in component for electrical systems, which can only be operated as an integral
part of such systems. Before the products are installed, the following requirements must be
fulfilled to meet the prescribed use.
• Anyone who works with the products in any way has to read and understand the
safety instructions, the prescribed use and the non-prescribed use.
• The machine builder has to generate a safety analysis for the machine to ensure
that unforeseen movements cannot cause injury or damage to personnel or
property.
• The servo drive has to operate under the mounting and installation conditions
described in this documentation, especially the environmental conditions
(temperature, protection class, humidity, mains input, EMC and the mounting
position)
• It must be mounted in a closed switchgear cabinet with minimum IP54.
• The servo drive has to be used in the way in which they are delivered (without any
mechanical or electrical modification).
• Do not mount or start-up mechanically or electrically damaged or faulty
components.
• The servo drive is intended to control synchronous servo, linear, torque and
asynchronous motors in closed loop control of torque, speed or position.
• The rated voltage of the motor must be at least as high as the setting of the mains
input voltage (230 V, 400 V or 480 V) of the servo drive system.
• Only motors with star-connection may be used.
• The servo drive is developed for usage in an industrial environment. If it is used in
residential areas, then an additional filter must be installed in the mains input line
• Power supply modules MDP101-1 and MDP 102-1 are to be used with axis
modules MDD111-1 and MDD121-1 only.
• Drives must to be used with motors provided with over temperature sensing.
To Next Page
Loading...
Need help?
General