MDP 101-1
Page 10 05.06.2020
2.4 Prescribed use
The safety module "Safe Restart Lock" in an integral component of the DIAS Drive MDP
101-1 and is already installed with delivery; it meets the conditions required for safe
operation according to SIL 3 in compliance with IEC 62061 and according to PL e in
compliance with EN 13849-1.
Safety modules can only be powered by supplies that meet the requirements for
PELV in compliance with EN60294.
Installation, mounting, programming, initial start-up, operation, maintenance and
discarding of safety modules can only be performed by qualified personnel.
Qualified personnel in this context are people, who have completed training or
have trained under supervision of qualified personnel and have been authorized
to operate and maintain safety-related equipment, systems and facilities in
compliance with the strict guidelines and standards of safety technology.
For your own safety and the safety of others, use safety modules for their
designated purpose.
Designated use also applies to correct EMV installation.
Non-designated use in this context applies to
• Any changes made to the Safety modules or the use of damaged
modules
• The use of the Safety modules outside of technical framework described
in these operating instructions
• The use of the Safety modules outside of the technical data described in
these operating instructions (see the "Technical data" sections of the
respective production).
In addition, observe the warnings in the other sections of these
instructions. These instructions are visibly emphasized with a symbol.
To Next Page
Loading...
Need help?
General