MDP 101-1
Page 36 05.06.2020
Avoid condensation also by observing the following rules:
• Set the set point of the temperature control of the cooling unit
minimal to the temperature of the factory building.
• Use only properly sealed switchgear cabinets to avoid condensation
by the moist external air.
• Especially during installation or servicing while the machine is
running with open switchgear cabinet doors, make sure that the
temperature of the electronic devices is not cooler than the air in the
switchgear cabinet. This will generate condensation in the electronic
devices.
To Next Page
Loading...
Need help?
General