UNOCODE 299 Operating manual - English
18 Copyright Silca 2002
5 OPERATING GUIDE
Introduction
The Operating Guide below explains how to use the UNOCODE 299 without a Personal Computer
.
All operations to manually use the key-cutting machine are explained step by step
.
The programs available for Personal Computers connected to the key-cutting machine are able to
transmit data for cutting
.
Programs for Personal Computer eliminate manual procedures of certain functions, once the data has
been transmitted to the machine it bypasses some of the operating guides screens
.
When the UNOCODE 299 is used with a Personal Computer, the operating guide does not change
its displays logic, with the exception of all the screens that are rendered unnecessary
.
5.1 INITIAL OPERATIONS
When the key-cutting machine has been placed on its workbench and connected to the mains
(ch.3.3,
page 10),
proceed as follows
:
1)
make sure that the emergency button is not turned on
.
2)
turn the machine on by means of the main switch that is located on the back of the machine
.
3)
to check or alter the parameters for use of the machine, consult the
"Options [6]"
menu
(ch.5.7,
page 36).
When the machine is turned on, for a few
seconds the display shows the internal
software version and the machine model
:
M
AIN
M
ENU
Operational keys:
use the keys to move the cursor to the option required
and press ENTER or directly press the numbered key
corresponding to the option number.
The
>>
symbol indicates that the menu contains other items
which can be reached with the arrow key
.
UNOCODE 299
version 1.0.023
1 - Copy by code
2 - List of codes
3 - Queue from PC
4 - Calibrations >>
5 - Maintenance
6 - Options
To Next Page
Loading...
