Need help?Do you have a question about the Silca Unocode 399 Plus and is the answer not in the manual?
Details the machine's key features and components.
Outlines safety precautions and protective measures for the operator.
Identifies and describes the primary components of the machine.
Provides specifications like power, dimensions, mass, and noise level.
Lists the tools and accessories included with the machine.
Explains how the machine is packaged for safe transportation.
Provides step-by-step instructions for removing the machine from its packaging.
Details safe procedures for moving and handling the unpacked machine.
Advises on inspecting the machine for any damage after transport.
Specifies ideal temperature and humidity for machine operation.
Guides on placing the machine on a workbench and connecting power.
Lists the controls available to the operator at the workstation.
Mentions a warning label on the machine for cleaning purposes.
Explains how to use the four-sided clamp for gripping keys.
Details the procedure for attaching and removing the clamp unit.
Introduces the standard cutter and mentions special cutters.
Provides instructions for replacing the cutting tool.
Describes the machine's keypad layout and function keys.
Outlines the initial steps required before operating the machine.
Explains how to cut keys using data cards.
Describes how to save and use frequently used data cards.
Details advanced options like manual adjustments for data card operations.
Covers scenarios like non-feasible combinations during key cutting.
Addresses issues where entered cuts are incompatible.
Explains how to access protected data cards requiring authorization.
Describes how to use the PC queue for job management.
Details how to create, edit, and manage custom data cards.
Explains the self-setting procedures for machine components.
Provides steps to calibrate the machine's standard jaws.
Guides on calibrating the cutting tools.
Explains the calibration process for optional adapters.
Covers routine maintenance and diagnostic tests.
Describes tests for the machine's motors.
Details testing the digital inlet signals.
Explains how to test digital outlet functions.
Describes testing all keys on the keypad.
Guides on testing the machine's display.
Explains how to test the serial port connection.
Covers the self-setting procedure for machine zero points.
Details how to adjust photocells and sensors.
Allows configuration of machine parameters and settings.
Explains how to enable protected systems.
Lists and explains various system messages.
Provides explanations for attention-type messages.
Lists and explains system error messages.
Explains different alarm messages and their causes.
Lists and explains messages related to Codemaker functions.
Lists faults and their probable causes for troubleshooting.
Lists common maintenance tasks.
Step-by-step guide for replacing the cutting tool.
Instructions for replacing and adjusting the machine belt.
Details how to check and replace fuses.
Guide for replacing the main electronic circuit board.
Instructions for replacing the keyboard and display unit.
How to access the rear section of the machine.
How to access the bottom section of the machine.
Guides on replacing X and Y axis sensors.
Instructions for replacing X and Y axis photocells.
How to replace the machine's internal battery.
Explains using the Win-transfer program for software updates.
Explains the procedure for requesting technical service and warranty.
To Next Page
General
