Silca Unocode 399 Plus - Reference Guide

Operating manual - English Unocode 399 PLUS
Copyright S ilca 2010 1
REFERENCE GUIDE
This manual has been produced to serve as a guide for users of the UNOCODE 399 PLUS electronic key-
cutting machine. Read it carefully; it is essential if you wish to operate your machine safely and efficiently
.
C ONSULTATION
The contents of the manual are divided into sections relating to :
• Machine description ................................................................................. Chapter 1
• Transport and installation ........................................................................... Chapters 2-3
• Regulation and use ................................................................................. Chapters 4-5-6
• Maintenance ... .............................................................................. Chapters 7-8-9
T ECHNICAL TERMS
Common technical terms are used in this manual.
To assist those with little experience of keys and key-cutting, bel ow is an illustration of the terms most
frequently used
.
Fig. 1
1) Head
2) Rim
3) Stop
4) Stem
5) Tip
6) Back
7) Cuts
CARD NUMBER:
Silca nu mber f or cu tting b y c ode on Si lca e lectronic
machines for flat keys.
Fig. 2
2
1
5
3
6
4
1
3
7
5
7
2
NUMERO SCHEDA
Card Number
FROM SILCA KEY CATALOGUE