Unocode 399 PLUS Operating manual - English
12 Copyright S ilca 2010
3 MACHINE INSTALLATION AND PREPARATION
The key-cutting machine can be installed by the purchaser and does not require any special skills.
It is supplied ready for use and does not need any special s et up. However, the operator may have to
control a few things before operating the machine
.
3.1 CHECKING FOR DAMAGE
UNOCODE 399 PLUS
is solid an d compact and will not normally damage if transpor t, unpacking and
installation have all been carried out acco rding to the instructions in th is manual. However , it is always
advisable to check that the machine has not suffered any damage
.
3.2 ENVIRONMENTAL CONDITIONS
To ensure that the best use is made of the key-c utting machine, it is important to place it in a well-aired
area which is not too damp
.
The ideal conditions for the machine are
:
temperature between 10°C and
40°C;
relative humidity: approx
60%
3.3 POSITIONING AND INSTALLATION
1) Place the machine on a horizontal surface, solid enough to support the weight of 51 Kg.
-
to work with ease, we suggest that the workbench be approximately the height of the operator’s
hip
.
-
it is im portant to leave clearance of at least 30 cm behind the machine and on each side to
ensure proper ventilation
.
2) Ensure th at the machines voltage is the same as that of the main s power supply, which must be
properly earthed and provided with a differential switch.
3) Connect the power supply cable to the power supply socket.
Fig. 9
To Next Page
Loading...
