Silca Unocode 399 Plus - General

Unocode 399 PLUS Operating manual - English
2 Copyright S ilca 2010
GENERAL
UNOCODE 399 PLUS has been designed in compliance to the European Community normative (CE).
From the design stage, risks for the operator have been eliminated in all areas: transport, regulation, cutting
and maintenance.
Further risks have been eliminated by means of protective devices.
The materials used to manufacture this machine and all its components are not hazardous
.
U SE
UNOCODE 399 PLUS is designed for cutting keys of ferrous materials: brass, silver nickel, etc.
It must be installed and used according to the instructions indicated by the manufacturer.
If the key-cutting machine is used differently or for purposes different from those described in this manual,
the customer will forego any rights he may have over Silca S.p.A. Furthermore, unforeseen danger to the
operator or any third parties may arise from incorrect use of the machine .
I NSTRUCTIONS MANUAL
The instructions manual provided with the machine is essential to its proper use and to carry out the
necessary maintenance.
We therefore recommend protecting th e manual from da mage in a safe sheltered p lace, easily to
hand for quick consultation.
I NCORRECT USE
Operator negligence resulting in improper use o f this machine or failure of the operator to observe the
instructions written in this manual. The manufacturer may decline all guarantees and responsibilities.
It is therefore essential to carefully read this operating manual .
F URTHER RISKS
No further risks will arise when properly using the UNOCODE 399 PLUS.
P ROTECTION AND SAFETY PRECAUTIONS FOR THE OPERATOR
UNOCODE 399 PLUS is entirely built in compliance to the Machine Directives. The operations for which
it has been designed are easily carried out with no risk to the operator
.
The ado ption of general safety pr ecautions and observation of the instructions prov ided by the
manufacturer in this manual eliminate all human error, unless deliberate
.
UNOCODE 399 PLUS
is designed with features which make it completely safe .
• Power supply
UNOCODE 399 PLUS is supplied with electricity by means of a grounded plug and differential switch .
• Pneumatic power
With compressed air .
• Start-up
The machine is turned on by means of a master switch that is located on the Unocode’s lower left back side .
• Maintenance
The operations to regulate, service, repair and clean the machine are structured in the simplest and safest
way possible. Parts that the operator can dismount cannot be incorrectly replaced therefore avoiding any
risks .