Silca Unocode 399 Plus - 5.11.3 ALARM MESSAGES

Operating manual - English Unocode 399 PLUS
Copyright S ilca 2010 59
5.11.3 ALARM MESSAGES
• The electronic control board has exceeded the maximum permitted temperature. Check the cooling
fan (SEE chap.7.1 "Trouble shooting", page 63).
• Indicates that the fuse has blown due to a short circu it in an inlet or outlet (see chap.7.1 "Trouble
shooting", page 63).
• Indicates a short circuit in port P (IN/OUT) (see chap.7.1 "Trouble shooting", page 63).
• Indicates that the fuse has probably blown (see chap.7.1 "Trouble shooting", page 63).
• Indicates a fault on the electronic control board.
• This message appears when the machine detects an unexpected contact.
• This message appears when gauging a clamp that requ ires the previous gauging of the standard
V100 clamp.
ALARM 2
TEMPERATURE ALARM
Turn the machine off!
ALARM 3
I/O POWER ALARM
Check fuse F4!
ALARM 4
DIGITAL OUTLET
PROTECTION ALARM
Turn the machine off!
ALARM 5
CUTTER MOTOR
ALARM
Check fuse F1!
ALARM 6
CUTTER MOTOR
Fault on motor circuit!
Faulty contact made!
Press START to move
axis at zero point.
Before calibrating the jaw:
V...
it's necessary to have
calibrated the V100 jaw