Unocode 399 PLUS Operating manual - English
44 Copyright S ilca 2010
5.8 MAINTENANCE
From the initial screen press MENU then F2 to enable the function.
Use the up/down arrow keys to select the option and
press ENTER, or di rectly press the key relating to
the option number.
5.8.1 MOTOR TESTS
Read the instructions on the di splay carefully a nd
check th at the carria ge (or option al clamp in the
case of B) for the axis involved moves.
ATTENTION: during this test function all end of run
controls are disactivated; avoid moving the carriage
up against its mechanical stops.
5.8.2 DIGITAL INLETS TEST
- Lift and lower the pr otective shield checking that
the machine’s display i ndicates OFF (with shield
raised) to ON (with shield lowered).
Note: if the ON/OFF transition is not made, contact
Silca’s Technical Assistance Dept.
Jaw acknowl edgement: operational only with
electrically connected device.
This test can be carried out only when an automatic
feeder (or other optional component) is installed
on
the machine
.
To Next Page
Loading...
