Silca Unocode 399 Plus - 2.2 UNPACKING; 2.3 MACHINE HANDLING

Operating manual - English Unocode 399 PLUS
Copyright S ilca 2010 11
2.2 UNPACKING
To remove the machine from the packing box :
1) cut the straps with scissors and remove
2) raise the top part of the cardboard box
3) loosen the screws, both on the front and back brackets that hold the machine to the pallet
4) use the special spanner (provided in the tool kit), to loosen the nuts on the machine’s feet
5) remove the metal brackets and re-tighten the nuts on the feet.
6) check the contents in the box, that should comprise with the following:
1 UNOCODE 399 PLUS key-cutting machine
1 set of documents, including: an operating manual, a spare parts list and a guarantee
1 power supply cable
1 tool kit
Note: we strongly recommend you keep the packing intact for future transportation
2.3 MACHINE HANDLING
When the UNOCODE 399 PLUS has been unpacked, place it directly on its workbench; this operation
should be carried out by at least two people.
Take care to lift the machine firmly holding the base, and no other part.
ATTENTION: never lift the machine by holding the keyboard stand (fig. 8).
Fig. 8
INCORRECT! CORRECT !