Unocode 399 PLUS Operating manual - English
16 Copyright S ilca 2010
4.2 FITTING THE CLAMP TO THE MACHINE
To remove the clamp unit:
- loosen the grub s crew (D2) ( fig. 17) and s lide the
clamp out of the dovetail guide.
To install the clamp unit on the machine:
- slide the clamp into the do vetail guide, pushing it all
the way in, then secure it by tightening the grub screw
(D2).
These instruction s refer exclu sively to th e stan dard
clamp (V1 00). For the use of option al cl amps please
refer to the instructions provided along with them.
Fig. 17
4.3 CUTTER
The majority of keys utilize the standard cutter for code cutting. Only in certain cases some spe cial
keys with particular type cuts require different cutters.
To change the cutter see chapter 4.4.
4.4 CHANGING THE CUTTER
1) raise the protective shield.
2) remove the cutter protective shield (i) by loosening the screw (i2).
3) slide the cutter release rod (X) into the hole located on the left side of the machines cutter shaft chassis
(fig. 18).
4) loosen the cutter locking nut (turning it clockwise) with the19 mm socket wrench (X1) provided with the
machine.
ATTENTION: the thread is left-handed.
5) replace the cutter, then tighten the nut (turning it anticlockwise) and remove the rod from its hole.
6) place the cutters protective shield (i) back into position securing it with the screw (i2).
Fig. 18
ATTENTION: when replacing a worn cutter with a new one or with a re-sharpened cutter consult
chap.5.7 "GAUGING", page 40.
To Next Page
Loading...
