Silca Unocode 399 Plus - 5.11.4 CODEMAKER MESSAGES

Unocode 399 PLUS Operating manual - English
60 Copyright S ilca 2010
5.11.4 CODEMAKER MESSAGES
• Appears when the depth value exceeds the key blank measurement assigned to the key.
• Appears when the set angle is higher or lower than the limit allowed by the cutter in use.
• Appears when the set depth is higher or lower than the limit for the clamp in use.
• Appears when the value of a set space is not within the limit.
• Appears when the value of a set flare is not within the limits.
• The set combination of spaces and flares exceeds the maximum run allowed for the space axis.
• Appears when the value of a set flare would overlay a previous flare.
• Appears when the value of a space is altered i n such a way as t o cause t he flare to overl ay the
previous one.
Key Blank dimension
out of range!
Limit values:
Cutting angle out of range!
Limit values:
Cutting Depth out of range!
Limit values:
Spacing value out of range!
Base of cut out of range!
Limit values:
Cutting process exceeds
X axis carriage range !
See operating manual.
Overlapping base of cut!
Spacing values
are not compatible
with base of cuts!