Silca Unocode 299 - 5.5.1 CALIBRATING THE V100 CLAMP

Operating manual - English UNOCODE 299
Copyright Silca 2002 29
5.5.2 CALIBRATING CUTTERS
For this procedure always use side A of the
V100 clamp.
According to the cutter speed (determined by
fitting the pulleys in the way described in ch.4.7,
page 17) and material (chosen from the ‘Options
– cutter material’ menu on page 36) the list will
show all the HSS or hard metal carbide cutters
(distinguished by the suffix ‘W’).
1) enter the “cutters” menu #2.
Operational keys:
use the arrow keys to move the cursor to select the
required cutter and press ENTER.
2) fit the selected cutter to the machine.
3) fit a brand new (Z3) template on side A of the
V100 clamp.
4) close the shield and proceed with setting the
cutter by pressing START.
- the display shows the differences from
the theoretical values.
NOTE: the setting will be accepted only if the
tolerance of the cutter’s diameter
remains within a range between +10 /–
100 hundredths of a mm.
- if the tolerances exceed the accepted
range the machine’s display will show
an error message:
- carefully follow the instructions and re-
peat the procedure
ATTENTION: Once this operation is completed the (Z3)
template must be discharged of; contact
with the cutter skims the surface of the
template therefore it would cause errors if
used for future settings.
1 - Clamps
2 - Cutters
3 - Adaptors
Cutters
00 - U01
01 - 01
02 - 02
00 - U01
Adjustment:
Y = +00
To calibrate [START]
00 - U01
Install the Z3 template.
See operating manual.
[START]
00 - U01
Detection
in progress!
00 - U01
Adjustment: +002
Save data?
No = Stop Yes = ENTER
Exceeded setting
tolerance limit
See operating manual
ENTER
ENTER
ENTER
ENTER
START
START