UNOCODE 299 Operating manual - English
36 Copyright Silca 2002
5.7 OPTIONS [6]
1)
Enter ‘Options’ menu # 6
.
Operational keys:
use the keys to move the cursor to the option required
and press ENTER or directly press the numbered key corre-
sponding to the option number.
1-
S
ERIAL NUMBER
:
displays the machine’s serial number that should
correspond to the serial No that is stamped on
the back of the machine.
Model
:
type of Unocode.
Keys cut
:
numbers of keys cut.
SW Version
:
Software version of the program installed on the
machine.
2-C
UTTER MATERIAL
:
The option ‘cutter material’ shows all the HSS
(enter 0) or hard metal (enter 1) cutters.
By inverting the pulleys two cutter rotation
speeds can be obtained:
• low speed for HSS tools
•
high speed for hard metal carbide tools
Inversion of the pulleys gives the first or second
speed according to the method described in
ch.4.7, page 17.
3-
C
UTTING SPEED
:
Corresponds to the carriage advancement
speed during the key cutting operation:
On the basis of the cutter material selected,
speed can be altered as shown in the table.
cutter metal
Recommended
speed
Speed Range
HSS 300 100-400
Hard metal
carbide
400 200-700
5 - Maintenance
6 - Options
ENTER
1 - Serial No.
2 - Cutter material
3 - Cutting speed
4 - Carriage speed >>
5 - Min. distance
6 - Modify keys stop
7 - Preference
8 - Language >>
10-Invers. keyboard
11-Cutting check
12-Protected Systems
Ser. n: 153214523123
Model : 299
Keys cut : _ _ _
SW Version : _._._
Cutter Material = 0
(0 = HSS )
(1 = Hard metal )
See operating manual
Cutting speed
HSS Hd. Met.
300 400
(100-400) (200-700)
To Next Page
Loading...
